Trip Computer Screen - Uniden TRAX350 Owner's Manual

How Do I Use It?
Most of the fields on this screen have a
shows whether the field it is attached to is shown on the map as a Trip Data.
It also shows the position of the data as follows:
Symbol Description
This value is not shown on the map screen.
This value appears on the map screen in the Trip Data area.
This is the value at the top.
This value appears on the map screen in the Trip Data area.
This is the value in the middle.
This value appears on the map screen in the Trip Data area.
This is the value at the bottom.

Trip Computer screen

The Trip Computer screen provides collected trip data. It can be opened
from the Trip Information screen by tapping
The fields on this screen are continuously updated while you keep the
screen open.
You can switch between the trips, pause then resume them, or reset their
data.
You have the following functions on this screen:
Page 88
If you tap the previous button,
this one replaces it.
Tap this button to
change the content of
the Route Data fields
to show information
about the next via
point.
Tap this button and
the Route Data fields
show information
about the final
destination again.
symbol next to them. This symbol
.