Table of Contents
Advertisement
CONNECTING EXTERNAL VIDEO SOURCES
CONNECTING AN S-VIDEO SOURCE TO INPUT 3, 4 AND 5
1.
Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the INPUT (S-VIDEO) jack, as shown on the TV
set below.
2.
Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack.
3.
Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack.
4.
Press the VID3~VID5 button to view the program from the VCR or laserdisc player. The VIDEO OSD label disappears
automatically after approximately four seconds.
5.
Press the ANT button to return to the previous channel.
NOTES:
1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is
played back will be abnormal if the connection is loose.
2. A single VCR can be used for VCR #1 and VCR #2 (see page 11), but note that a VCR cannot record its own video
or line output. Refer to your VCR operating guide for more information on line input-output connections.
ANT A
P
R
INPUT 1
R
(MONO)/L
TO
CONVERTER
P
R
INPUT 2
ANT B
R
(MONO)/L
(MONO)/L VIDEO
R
INPUT 3
AUDIO
TO HI-FI
R
(MONO)/L
CENTER
INPUT 4
IN
IR
BLASTER
R
MONITOR
L
OUT
AUDIO
R
OUTPUT
R
VCR
DVI-HDTV
P
Y
B
IEEE1394
AUDIO
P
Y/VIDEO
B
Multi Media Card
AUDIO
S-VIDEO
VIDEO
S-VIDEO
L
VIDEO
S-VIDEO
L
V
S-VIDEO
17
OPTICAL OUT
Digital Audio
ANT C
(DTV)
Advertisement
Table of Contents
