Cisco Linksys PLWK400 User Manual page 50

Linksys PLWK400
6. If this solution does not work, make sure that the electrical outlet is
working properly Plug a different device into the outlet, and try to turn
it on
You cannot connect to other computers on your local network or to the
Internet.
If you did not set up advanced security for the Powerline network, follow these
instructions:
1. Locate the Powerline adapter connected to the computer that cannot
connect
2. On the left side of the adapter, use a pointed object to press and hold the
Standby/Reset button for at least ten seconds This resets the adapter to
its factory default settings
If you have set up advanced security for the Powerline network, check the
following:
• Make sure all adapters on the Powerline network have been configured
with the same network password The network password must be
identical in order for them to communicate with each other See "Setting
up advanced security" on page 8" or "Using the Utility" on page 8
•
If you are adding a new adapter to a pre-existing Powerline network with
a unique network password, follow the instructions in "Using the Utility"
on page 8
The LEDs are flashing and I don't know what it means.
Refer to the following table of LED behavior to help diagnose the problem:
Off
Flashing fast
Powerline LED
Flashing slow
Solid
Off
Ethernet LED Flashing
Solid
Off
Wireless LED
Solid
(PLW400 only)
Flashing
Flashing slow
Wi-Fi Protected
Setup
Flashing fast
(PLW400 only)
Solid
Off
Solid
Flashing fast
Power LED momentarily
Flashing fast
indefinitely
Flashing slow
WEB
If your questions are not addressed here, go to the Linksys Support
website at Linksys.com/support
Troubleshooting
Not connected to Powerline network
Send/Receive data
Pairing
Connected to Powerline network
Not connected to Ethernet network
Send/Receive data
Connected to Ethernet network
Wireless not connected
Wireless enabled
Send/Receive data
Connection in progress (up to two
minutes)
Connection error
Connection successful
Device power off
Device power on and ready
Factory default (both models), device
wakeup from standby mode (PLE400
only)
Pairing error/system error
Device in standby mode (PLE400 only)
11