Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
HOW TO CLEAN THE IONIZER
Make sure the interactive stand is turned off. Remove
the ionizer and wipe the steel blades with a soft, damp
cloth. Press the ionizer back onto the console. Make
sure the ionizer is fully seated.
Ionizer
The console, upright, and base can be cleaned in the
same way. To reduce the possibility of electric shock,
avoid spilling liquids on the interactive stand.
INTERACTIVE STAND TROUBLESHOOTING
Problem: Your exercise equipment does not
respond to signals from the interactive stand.
Solution: Press and hold down the Ionizer button for
about ten seconds to select the test mode. The light
above the Ionizer button will begin to flash. Move the
interactive stand until the console of your exercise
equipment sounds a tone. If the console doesn't
sound a tone, call our Customer Service Department
toll-free at 1-888-825-2588. To exit the test mode,
press and hold down the Ionizer button for another ten
seconds.
Problem: The interactive stand does not respond
to the remote control.
Solution: Make sure you are pointing the remote con-
trol at the interactive stand.
If the interactive stand still does not respond, replace
the batteries in the remote control and the interactive
stand (see assembly steps 6 and 3).
Problem: The interactive stand cannot be turned
on.
Solution: If the interactive stand is operating from the
power supply, make sure the power supply is properly
connected (see assembly step 3). If the interactive
stand is operating from batteries, replace the batteries
(see assembly step 3).
If the interactive stand still cannot be turned on, see
the drawing below. Tip the base onto its side and
unscrew the fuse cover. Remove the old fuse from the
fuse cover and insert a new 1 amp fast blow fuse.
Reattach the fuse cover.
Base
8
Fuse
Fuse
Cover
Advertisement
Table of Contents
