Filling The Boiler Tank Before Use; Turning On The Appliance; Filling The Boiler Tank During Use - Eureka 370 Series Owner's Manual

FILLING THE BOILER TANK BEFORE USE

NOTE: Before unscrewing the safety cap, always be sure that the cleaner is off and unplugged from the electrical
outlet.
9. Unscrew safety cap and using funnel, pour into the tank one
measuring cup (included) filled with water to the maximum level.
Screw safety cap back on.
(Always empty the Multi-Steamer after use to avoid
overfilling.)

TURNING ON THE APPLIANCE

10. Plug the appliance into an electrical outlet.
Press on/off switch. The green (power) indicator light and the amber (steam ready) indicator light will both come on. As
soon as the amber (steam ready) indicator light goes out, the appliance is ready for use. Press steam delivery button to
supply steam. To prevent steam from being accidentally supplied, shift back safety slider to the
CAUTION: When using the steam cleaner for the first time, keep the gun higher than cleaner
body. This prevents water forming in the hose. When first using the cleaner and
every time it is left unused for a few minutes, press steam delivery button and
discharge any water that has formed in the hose into a container. Then, as soon as
the cleaner begins supplying steam only, direct the steam jet towards the floor and
press steam delivery button at least two or three times.

FILLING THE BOILER TANK DURING USE

11. When the water runs out, steam is no longer supplied when steam delivery button is pressed. To fill up boiler tank. Follow
these steps:
a. Turn off the cleaner by pressing on/off button.
b. Unplug the cleaner from electrical outlet.
c. Press steam delivery button until all pressure has been released.
d. Wait for about 3 minutes before carefully unscrewing the safety cap.
e. Turn slowly a half turn and wait for the hissing noise created by residual steam to stop.
f. Unscrew the safety cap completely and allow to cool. CAUTION: Cap may be hot.
g. Slowly pour one measuring cup (included) into the boiler using the funnel (included). Do not overfill.
h. Screw the safety cap back on the appliance.
i. Plug the appliance into electrical outlet and press on/off button. Steam will start to be produced as before.
WARNING: This unit is under pressure. After every use, press steam delivery button until all pressure has been
released before removing safety cap.
Green (power)
Indicator Light
Amber (steam
ready) Indicator
Light
On/off Switch
position.
Steam Delivery Button
Safety Slider
9