DeLonghi Dragon HM3 Instructions Manual page 3

Thank you for choosing this De'Longhi radiator. To get
the very best out of your new radiator it is advisable to
read these instructions before using it. This will ensure
that you gain optimum results and use the appliance
safely.
General instructions
Take the radiator out of its packing box and remove any
polstyrene pieces or any other packaging material that might
be lodged inside it. Make sure that the radiator has not been
damaged during transit and that the mains cable is in working
order. Do not operate the radiator if damaged.
"Easy wheel"system
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint finish. Fully unfold the
castors by turning them outwards (Fig. 1). Turn the radiator
back to its upright position.
Using for the first time
On using the radiator for the first time we advise that you turn
it on to the maximum power setting for at least 8 hours.
This is to eliminate the "new odour", which is released by the
appliance. During this time ensure that the room is well
ventilated.
Electrical connection
- Before plugging the radiator into the mains, check that your
supply voltage is the same as that shown on the rating plate
of the appliance.
- If using more than one radiator at a time, it is important to
ensure that the ring main is adequate to cope with the
power requirements.
- It is important to ensure that the socket is adequately earthed.
- This radiator complies with EEC Directive 89/336 relating to
electromagnetic compatibility.
How to use your heater
Plug the radiator in and the power on light
Setting the clock (fig. 2)
Set the clock to the correct time, proceeding as follows:
• Press the "hour" button until the display shows the hours for
the correct time, then release the button.
• Press the "min" button until the display shows the minutes
for the correct time, then release the button.
When setting the correct time, the numbers will flash on the
display. The clock will continue to flash for a few seconds after the
adjustment has been made then stop on the correct time and start
3
Fig.1
will come on.
Fig.2