Warehouse And Factory - Cisco Aironet 1600 Deployment Manual

Cisco Aironet Access Point Deployment Guide
Figure 28: Metal Pins or Padlocks for Areas of High Vibration
Warehouse and Factory
Warehouse installations are often difficult because of the very high ceilings and the clutter of the
material in storage. As part of your site survey, always check the coverage when the warehouse is fully
stocked, since the material in storage can change the RF coverage and interfere with uniform coverage.
For aisles, use directional (patch) antennas on the wall and shoot down the aisles. You can also use low‐
gain omnidirectional antennas (such as dipoles) on the ceiling or units with integrated antennas; high
gain omnidirectional antennas tend to have more nulls. (See Figure 50.)
The higher the AP is mounted, the farther the signal must travel. Use pipe and electrical box mounting
techniques to lower the AP (external and internal antenna models) so that it is closer to users. (See
Figure 29.)
Cisco Systems
Copyright © 2012 Cisco Systems, Inc. All rights reserved.
Page 22 of 52