Mon800 Quick-Start Set-Up - Behringer Minimon Mon 800 User Manual

5
MINIMON MON800 User Manual

2. MON800 Quick-Start Set-Up

Computer
B-CONTROL
FADER BCF2000
Mix in A
MINIMON MON800
Fig. 2.1: MON800 quick-start set-up
Please follow the instructions below to set up the MON800 as a
monitor unit with different speakers in your studio.
•
Connect your computer or any other line-level source to the
MIX IN A connectors on the MON800.
•
Connect your main monitor speakers to the SPEAKERS OUT A
connectors, and another pair of speakers to the B outputs.
•
Press the MIX A switch in the SOURCE section.
•
Use the 2-TR OUT LED display to check the signal level. If the CLIP
LED lights up, please reduce the input signal level until it settles
between the -6 dB and +6 dB markings.
•
The switches A and B allow you to switch the pairs of speakers
on and off. Activate the A speakers and adjust the desired
volume with SPK A LEVEL.
TRUTH B2031A
Speakers Out A
•
Switch off the A speakers and activate the B speakers. Use SPK
B + C LEVEL to adjust a volume level that is roughly the same as
the A speakers volume.
•
Switch between the two pairs of speakers to check the volume
levels. Align the volume if necessary.
•
By switching between the two pairs of speakers you can
evaluate your mixes by way of a direct comparison using two
different monitor systems.
Digital Monitor
Speakers MS20
Speakers Out B