Advertisement
Quick Links
Advertisement
Summary of Contents for Vivotek AI-103
- Page 1 AI-103 IR Illuminator Installation Guide Rev. 1.1 IP Sur veillance...
-
Page 2: Specifications
Revision History: Rev. 1.0: Initial release Rev. 1.1: Changed effective IR range. Specifications Model Name AI-103 IR LED quantity 6 pcs IR light range 20 meters IR wavelength 850nm IR bean angle 60° IR light control. CTRL (+/-) by camera... - Page 3 Mounting & Cabling Preparing for installation: 1. Remove the IR illuminator from its package. 2. You should purchase power cords with adequate length. 3. A T20 hex wrench. Assemble the IR illuminator with the Support Bracket: Use the included hex wrench to slightly loosen the ball swivel to adjust the shooting angle.
- Page 4 Install the IR illuminator next to your network camera, e.g., IP8352. Orient its shooting angle by adjusting the ball swivel screw. Secure the illuminator by fastening screws through the holes on the base of the equipment stand. If you drilled a hole on the wall, you can pass power and control lines through the hollow of the equipment stand and then through the hole Wiring There are 5 wires with the illuminator: 3 for power connections and another 2 as control...
- Page 5 AC Power Connection Power lines are connected to a connection block. Use them to connect the power cords you separately purchased. Control Line Connection Disassemble the waterproof connector through which you will route your control lines to the IR illuminator. Rubber ring (A) Screw nut (B) Rubber seal (C)
- Page 6 1. Open the rear cover using a flathead screwdriver (taking the IP8352 as an example). 2. Replace the seal plug on the rear cover with parts A & B from the waterproof connector. 3. Pass digital IO lines through F > E > C > A+B. Insert D into unused holes on C. 4.
- Page 7 IR Configuration To configure the IR-related settings in camera firmware: 1. Open a browser management session according to your QIG (Quick Installation Guide). 2. On the main page, enter Configuration > Advanced mode > Media > Image (General settings) > click on a tab at the lower screen to open Day/Night settings. 3.
- Page 8 IP Sur veillance...