Using The Wireless Remote Control; Dubbing From The Camera/Recorder To A Vcr - Hitachi VM-E53A Instruction Manual

Advanced Techniques
3. Use the PLAY button to select a title from memory.
4. Press the TITLE ON/OFF button on the remote control to turn title off.
5. Turn on the VCR and set it to record. Hold down the red button on the
CAMERA/OFF/VIDEO switch while sliding the switch to VIDEO. Press PLAY on the
camera/recorder.
6. Press the TITLE ON/OFF button on the remote control at the point on the tape where
you wish to record the title.
7. Press the TITLE ON/OFF button on the remote control again to stop recording the
title.
Note: Recording the title during tape transfer will erase a portion of your recorded material.

Using the Wireless Remote Control

Use the wireless remote control to operate the camera/recorder from a distance. The
PLAY, F.FWD, REW, STOP, PAUSE (START/STOP) and ZOOM buttons on the
wireless remote control operate the functions of the corresponding buttons on the
camera/recorder. Aim the wireless remote control at the infrared ray receiver of the
camera recorder.
Wireless Remote Control Range/Angle
Note: Use the wireless remote control within the range of the infrared ray receiver of the
camera/recorder shown above.
Note: The wireless remote control may not function in strong light such as direct sunlight or
very bright artificial lighting.
Note: Clear a direct path from the wireless remote control to the infrared ray receiver. The
wireless remote control won't work if an obstacle blocks the infrared rays.
Note: The remote control code of this camera/recorder is Hitachi code VCR2. If you have a
VCR with the same code you Hitachi VCR may malfunction when you use the
camera/recorder's wireless remote control.

Dubbing from the Camera/Recorder to a VCR

Connect the camera/recorder to a VCR to copy your or a friend's home 8mm recordings
to VHS.
Dubbing Diagram
1. Connect the AV output cord plug to the AV IN/OUT jack of your camera/recorder.
49