LSC SC-8 SYSTEM User Instructions page 4

SC-8 System™
details, refer to the T16F user instructions.
5. Flash Button - Pressing and holding the desired buttons will
allow you to turn on the corresponding channels temporarily.
Releasing the desired buttons will turn off the channels.
6. Control Output - Using the included 9-pin com cable, connect the
SC-8 controller to the SRP8 power pack. When using the cable for
connection, up to two power packs can be controlled by this unit.
7. Foot Control Connector - Connection for the use of the T16F.
8. Fuse Holder - This housing stores the protective 3 amp fuse.
Always replace with the same exact fuse.
9. AC Input - Connects to a standard AC outlet.
LSC - www.lightstreamcontrols.com - SC-8 System™ Instruction Manual Page 7
© ®
Functions and Controls SC-8 System™ Rear Connections and Functions
10
10. 9-Pin Output Connection - This connection is used to link up
other power packs. Up to two power packs can be controlled
by this unit.
11. 9-Pin Input Connection - Using the included 9-pin com cable,
connect the SC-8 controller to the SRP8 power pack.
12. Circuit Breaker - This 15A circuit breaker protects against the
risk of electrical shock or fire and protect the circuitry. In the case
of an internal short or power surge.
13. AC Input - Connects to a standard AC outlet.
LSC - www.lightstreamcontrols.com - SC-8 System™ Instruction Manual Page 8
© ®
11 12 13