Table of Contents
Advertisement
Message
Cannot sleep mode.
Cannot take still
image. Set Movie/
Still switch to
"Still".
Card almost full.
Card error has
occurred.
Card error has
occurred.
Format the card
now?
Card error has
occurred.
Formatting is not
complete.
Card error has
occurred. Keep card
inside & restart.
Card full.
Card is not
formatted.
Format the card
now?
Check card.
134
Cause & Troubleshooting
• The camcorder enters sleep mode when QUICK
START is pressed only while in recording pause mode.
• Check the following causes:
- there is no disc in the camcorder while the power
switch is set to "BD/DVD".
- there is no SD memory card in the camcorder while
the power switch is set to "SD CARD".
- the HDD, disc, or card does not have sufficient
remaining free space.
- An usable disc or card is inserted.
- the disc navigation screen is appearing.
- during playback
• This message will appear when PHOTO is pressed
with the movie/stills switch set to "
• You cannot record stills on HDD/BD/DVD. Use SD
card to record stills using this camcorder.
Remaining space is only enough to record less than 10
stills.
Delete unnecessary stills and try the card, or use another
card.
• The card terminals may be dirty. Wipe off dirt, and try
the card again, or use another card.
• Data other than still image may be included. Use
another card.
The card may have been formatted on a PC, or formatting
may have been interrupted. Choose "YES" to format the
card.
The card may be damaged. Try again or use another card.
Card error could have occurred during editing of scenes.
Turn off the camcorder with the card inserted, connect the
AC adapter/charger, and then turn it on again.
Delete unnecessary stills, or use another card.
Was the card formatted on PC? Choose "YES" to format
the card.
The inserted card cannot be used in this camcorder. Use
another card.
Reference
page
40
".
45
99, 170
32
104
32
37
99, 170
104
32
Advertisement
Table of Contents
