First Installation - Sagem DTR94 HD FREESAT User Manual

5. FIRST INSTALLATION

Once the recorder is physically connected, you need to go through the setup procedure to get your
freesat HD and SD channels.
1. Switch on your TV.
2. Press the Standby button on your remote control to wake the recorder up from standby mode.
3. The first installation screen should appear.
Freesat Settings
4. Press to start the installation.
The recorder searches for the freesat satellite
signal. Please wait until the recorder
successfully detects it.
5. If the detection fails, press
reception strength and quality of the satellite
signal(s). Check the dish cable connections.
When the signal level is satisfactory,
press to resume the installation.
If the level and quality of reception remain
insufficient, contact your satellite installer.
6. Enter your full postcode (without space) using
the alphanumeric keys on the remote control.
Example: to enter the letter S, press 4 times
key 7.
Use the
character.
Press to continue.
Note : the postcode is used to install local TV
and radio channels.
to view the
key to delete an incorrect
- 13 -