Extension Cords - Ryobi C-356 TYPE III Owner's Operating Manual

CUT-OFF MACHINE SAFETY
1. MAKE SURE THE CUT-OFF WHEEL lS SECURELY MOUNTED as described in the operating
instructions before connecting the toolto a power supply, Do not tighten wheel excessively, since this can
cause cracks.
Z. CHECK WHEEL FOR FISSURES AND CRACKS, and test for normal operation prior to use.
g. USE ONLY CUT-OFF WHEEL RATED FOR 3300 RPM OR GREATER and manufactured in compliance
with ANSI B 7.1. Always store wheels in a dry place with little temperature variation.
4. ALWAYS EASE THE ABRASTVE WHEEL AGAINST THE WORK PIECE when starling to cut. A harsh
impact can break the wheel.
5.
BEFORE CUTTING, press the trigger switch and allow the cut-off wheel to reach f ull speed before cutting.
6. IMPORTANT INFORMATION
ON THE USE OF CUT.OFF WHEELS AND ANSI B 7.1 CAN bE
obtained by writing to:
GR I N D I N G W H E EL I NS T IT UT E
30200 Detroit Road
Cleveland. OH 44145-1967
EXTENSION CORDS
When using a power tool at a considerable distance When working with the tool outdoors, use an extension
from a power source, use an extension cord heavy cordthatisdesignedforoutsideuse.
Thisisindicated
enough to carry the current that the tool will draw. An by the letters "VVA" on the cord's jacket.
undersized extension cord will cause a drop in line
voltage, resulting in a loss of power and overheating. Before using an extension cord, inspect it for loose or
A minimum 12 AWG (gage) extension cord no longer exposed wires and cut or worn insulation,
than 50 feet in length may be used with this tool. Only
round j a c k ete d co rd s l i st e d by U n d e r wr it e r ' s H a ve a d a m a g e d o r wo r n c or d r e p a ir ed o r r epl ac ed
Laboratories (UL) should be used. immediately.
Ampere rating
(on faceplate)
0- 2 .0
2,1 -3,4
3 . 5 - 5. 0 5 .1 -7 . 0 7 . 1 -12. 0 12. 1 -15. 0
C ORD LE NGTH
Wi re Siz e (A. W.G . )
CAUTION: Keep the cord away from the cutt
be caught on the mateiial, the tool, or other
ing area and position the cord so that it will not
obiects during operation.
2'',
1 6
1 6 1 6 16
14 14
5 0 '
1 6 1 6
1 6 14 14 12
Page 5