Demo/Dimmer Function; Setting The Clock - Samsung MAX-J530 Instruction Manual

DEMO/DIMMER function

All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
1
Press the DEMO/DIMMER button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
2
Press the DEMO/DIMMER button again.
Result: The Dimmer function is selected and the display darkens.
3
Press the DEMO/DIMMER button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically.
You should set the clock:
When you first purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing STANDBY/ON.
2
Press TIMER/CLOCK twice.
Result: CLOCK is displayed.
3
Press ENTER.
Result: The hour flashes.
4
To...
Increase the hours
Decrease the hours
When the correct hour is displayed, press ENTER.
5
Result: The minutes flash.
6
To...
Increase the minutes
Decrease the minutes
7 When the correct time is displayed, press ENTER.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing TIMER/CLOCK once.
You can also use /
TUNING / on the remote control to instead of MULTI
JOG knob in step 4, 6.
1
4,6
4,6
Turn the MULTI JOG knob to the...
Right
Left
Turn the MULTI JOG knob to the...
Right
Left
buttons on the panel front or
4,6
2
3,5,7
GB
9