Samsung Refrigerator User Manual page 16

setting up your refrigerator
 1
①
Separate the stopper(①) by removing
3 screws on the right side. (Refer to
the picture.) And replace them on the
right side. Remove 3 screws on the left
side. (Refer to the picture.) And then,
replace the stopper(①) separated from
the right side. And reattach it by using
those removed 3 left side screws on the
left side.

Assemble the left upper hinge on the
left side by using 3 bolts and reattach
the ground wire using 1 screw. You can
get the hinge from the installation tool
box supplied with your new Samsung
refrigerator. (Be careful not to tip over
the fridge door andhave wire damage.)
1_ setting up
1

After removing cap on the upper left
side of fridge door, reattach the fridge
door on the right side.

Assemble 2 connectors.
(If it is not connected, error message
will be shown on the display)
 1
Separate the cover on the left upper side
of refrigerator by removing 1 screw, and
reattach it on the right upper side. (Be
careful not to strip wire coating.)

Replace the left upper hinge cover with
using 1 screw. You can get it from the
installation tool box supplied with your
new Samsung refrigerator.
Check the door alignment, opening, and
inner lamp operation by opening the
fridge and freezer doors.