Table of Contents
Advertisement
system setup
SETTING THE DELAY TIME
Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each
speaker is the same.
Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can
adjust this difference by adding a delay effect to the sound of the Center and Surround Speakers.
Setting CENTEr SPEAKEr
If the distance of Dc is equal to or longer than the distance of Df
in the figure, set the mode as 0ms. Otherwise, change the
setting according to the table.
Distance between
0.00 m
0.34 m
Df and Dc
0 ms
1 ms
Delay Time
Setting rEAr SPEAKErS
If the distance of Dc is equal to or longer than the distance of Dr
in the figure, set the mode as 0ms.
Otherwise, change the setting according to the table.
Distance between
0.00 m
1.06 m
Df and Dc
Delay Time
0 ms
3 ms
M
`
With
PL II (Dolby Pro Logic II), the delay time may be different for each mode.
`
With AC-3 and DTS, the delay time can be set between 00 and 15mSEC.
`
The Center channel is only adjustable on 5.1 channel discs.
5
0.68 m
1.06 m
1.40 m
1.76 m
2 ms
3 ms
4 ms
5 ms
2.11 m
3.16 m
3.62 m
5.29 m
6 ms
9 ms
12 ms
15 ms
Ideal center speaker
placement
It is desirable to place all speakers within this circle.
Df: The distance from front speaker
Dc: The distance from center speaker
Ds: The distance from surround speaker
Ideal
surround
speaker
placement
Advertisement
Table of Contents
