Connecting The Video Out To Your Tv - Samsung HT-X725 User Manual

Connections
COnnECTInG THE OPTIOnAL WIrELESS rECEIVInG AMPLIFIEr (Con
M
`
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too
close to the main unit, some sound interruption may be heard due to interference.
` If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that
uses the same frequency (5.8GHz) near the system, some sound interruption may be heard due to interference.
`
The transmission distance of a radio wave is about 10m, but may vary depending on your operating
environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver
module, the system may not operate at all, because the radio wave cannot penetrate metal.
`
If the main unit doesn't make wireless connection, the system needs ID Setting between main unit and
wireless receiver module. With the main unit turned off, press the remote control's number button buttons
"0""1""3""5" and the main unit will turn on. With the wireless receiver module turned on, press "ID
SET" button on the back of the unit for 5 seconds.
J
`
Do not insert any other card except the TX card dedicated to the product. The product might be damaged or
the card may not be removed easily.
`
Do not insert the TX card upside down or in the reverse direction.
` Insert the TX card when the Home Cinema System is turned off. Inserting the card when it is turned on may
cause a problem.
`
If the TX Card is inserted, sound is not output from the Rear Speaker connectors on the main unit.
`
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
`
For optimal listening performance, make sure that the area around the wireless receiver module location is
clear of any obstructions.
`
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1 channel or Dolby ProLogic II.
`
In 2-CH mode, no sound will be heard from the wireless rear speakers.
0

COnnECTInG THE VIDEO OUT TO YOUr TV

Choose one of the three methods for connecting to a TV.
.)
METHOD 1 : HDMI
Connect a HDMI cable (not supplied) from the HDMI OUT jack on the back of the Home Cinema
System to the HDMI IN jack on your TV.
METHOD 2 : Component Video
If your television is equipped with Component Video inputs, connect a Component video cable (not
supplied) from the Component Video Output (P
System to the Component Video Input jacks on your TV.
METHOD 3 : Composite Video
Connect the supplied Video cable from the VIDEO OUT jack on the back of the Home Cinema System
to the VIDEO IN jack on your TV.
M
METHOD2 METHOD3
(supplied)
, P and Y) jacks on the back of the Home Cinema
R B
`
The resolution from the Component Output is 576i(480i).
`
If you use an HDMI cable to connect a Samsung TV to the Home Cinema System, you can operate the Home
Cinema using the TV's remote control. This is only available with SAMSUNG TV's that support Anynet+(HDMI-
CEC).
`
Please check the ' logo (If your TV has an ' logo, then it supports the Anynet+ function.)
METHOD1
1