Plug & Play Feature
When the TV is initially powered on, basic settings proceed automatically and subsequently.
1
Press the POWER button on the remote control. The message The Menu
Language, Store Demo, Channels, and Time will be set. is displayed.
Press the ENTER E button.
Press the ◄ or ► button to select Store Demo or Home Use, then the
ENTER E button.
We recommend setting the TV to Home Use mode for the best picture in
N
your home environment.
Store Demo mode is only intended for use in retail environments.
N
If the unit is accidentally set to Store Demo mode and you want to return to Home Use (Standard): Press the Volume
N
button on the TV. When the volume OSD is displayed, press and hold the MENU button on the TV for 5 seconds.
The Screen Saver is activated if there is no remote control key input for longer than 1 minute while Plug & Play is
N
running.
The Screen Saver is activated if there is no operating signal for longer than 15 minutes.
N
Press the ▲ or ▼ button to select the channel source to memorize. Press the ENTER E button to select Start.
Digital & Analogue: Digital and Analogue channels.
N
Digital: Digital channels.
Analogue: Analogue channels.
The channel search will start and end automatically.
N
Press the ENTER E button at any time to interrupt the memorization process.
N
After all the available channels are stored, the message Set the Clock Mode. is displayed.
N
4
Press the ENTER E button. Press the ▲ or ▼ button to select Auto, then press the ENTER E button.
If you select Manual, Set current date and time is displayed. (See page 26)
N
If you have received a digital signal, the time will be set automatically. If not, see page 26 to set the clock.
N
5
Select the time zone where you are located. is displayed. Press the ▲ or ▼ button to highlight the time zone for your local
area (and to move the highlight to the appropriate time zone on the map of the Australia).
Press the ENTER E button.
The message Enjoy your viewing is displayed. When you have finished, press the ENTER E button.
If you want to reset this feature...
1
Press the MENU button to display the menu. Press the ▲ or ▼ button to select
Setup, then press the ENTER E button.
Press the ENTER E button again to select Plug & Play.
Enter your 4 digit PIN number. The default PIN number of a new TV set is
'0-0-0-0'.
If you want to change PIN number, refer to 23 page.
N
The Plug & Play feature is only available in the TV mode.
N
Channel Control
Storing Channels and channel
Auto Store
❑
You can scan for the frequency ranges available to you (and availability
depends on your country). Automatically allocated programme numbers may
not correspond to actual or desired programme numbers.
•
Digital & Analogue: Digital and Analogue channels.
•
Digital: Digital channels.
•
Analogue: Analogue channels.
Scans for all channels with active broadcast stations and stores them in the
N
TV's memory.
If you want to stop Auto Store, press the ENTER E button.
N
The Stop Auto Store? message will be displayed.
N
Select Yes by pressing the ◄ or ► button, then press the ENTER E button.
N
If a channel is locked using the Child Lock function, the PIN input window appears.
N
English - 11
Plug & Play
The Menu Language, Store Demo, Channels, and Time
will be set.
OK
Plug & Play
Time
Network Selection
: Cable
Wireless Network Setup
Cable Network Setup
Child Lock
: Off
Change PIN
Parental Lock
Auto Store
Manual Store
Full Guide
Mini Guide
Default Guide
: Mini Guide
Channel List
Channel Mode
: Added Ch.
Fine Tune
E
Enter
►
►