Samsung LED TV User Manual page 26

✎
You can connect the LAN port and the TV directly according to your network status.
x
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
x
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least
10 seconds and then try again.
x
For the connections between the external modem and the sharer (router), refer to the owner's manual of the
corresponding product.
x
Do not use a manual-connection-type ADSL modem which does not support DHCP. Use an automatic-connection-
type ADSL modem.
✎
Connect the LAN via a sharer (router).
x
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
x
If you are using a static IP address, your ISP will inform you of the IP address, subnet mask, gateway, and DNS. Enter
these values to complete the network settings. If you do not know the values, ask your network administrator.
x
For the information on how to configure and connect a sharer (router), refer to the owner's manual for the
corresponding product.
x
If you use an IP sharer (IP router) that supports DHCP, you can set up the device as either DHCP or static IP.
x
For information on the procedures to use a static IP address, contact your Internet Service Provider.
Network Connection - Wireless
Connect to the network wirelessly through a wireless IP sharer.
1. Connect the "Samsung Wireless LAN Adapter" into the
C5000
The LAN Port on
the Wall
✎
NOTE
x
You must use the "Samsung Wireless LAN Adapter" (WIS09ABGN) to use a wireless network.
x
Samsung's Wireless LAN adapter is sold separately. The WIS09ABGN Wireless LAN adapter is offered by select
retailers, Ecommerce sites and Samsungparts.com.
x
To use a wireless network, your TV must be connected to a wireless IP sharer. If the wireless IP sharer supports
DHCP, your TV can use a DHCP or static IP address to connect to the wireless network.
x
Samsung's Wireless LAN adapter supports IEEE 802.11A, IEEE 802.11B, IEEE 802.11G, IEEE 802.11N. When you play
the video over IEEE 802.11B/G connection, the video may not be played smoothly.
x
Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer
is currently being used by another device nearby, this will result in interference and communication failure.
x
If you apply a security system other than the systems listed blow, it will not work with the TV.
x
When applying the security key for the AP (Access Point), only the following is supported.
1) Authentication Mode: OPEN, SHARED, WPAPSK, WPA2PSK
2) Encryption Type: WEP, TKIP, AES
When applying the security key for the Ad-hoc mode, only the following is supported.
1) Authentication Mode: SHARED, WPANONE
2) Encryption Type: WEP, TKIP, AES
x
If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC (Push Button
Configuration) or PIN (Personal Identification Number). WPS will automatically configure the SSID and WPA key in
either mode.
x
If the device isn't certified, it may not connect to the TV via the "Samsung Wireless LAN Adapter".
23
English
Wireless IP sharer
LAN Cable
USB 1 (HDD) or USB 2 terminal of the TV.
TV Side Panel
or
Samsung Wireless
LAN Adapter