Connecting To A Tv Antenna - Daewoo DSL19M1WC Instruction Manual

System Connections

Connecting to a TV Antenna

Connect TV signal source from the aerial to the TV jack on the rear panel of the unit.
After connection, turn on the power of the unit. Then press the SOURCE button to select TV mode
and conduct program selection. You can follow the steps below to select channels:
However, if this is the first time the TV has been used, you must first search and store the
channels by following the steps on pages 18, 19, 20 and 21.
1. For 1~9 channel:
Press one of the number buttons to select the desired channel X, and wait several seconds and
it will go to the selected channel.
Or press the number buttons to select the desired channel X, and press the ENTER button to
go to the selected channel immediately.
Or press the number buttons to select channel 0X, and it will go to the selected channel
immediately.
2. For 10~99 channel:
Press the number buttons to select channel XX, and it will go to the selected channel
immediately.
X is the channel number.
- 13 -