Utilitech UT-5571-BZ Installation Instructions

Item Model
247590 UT-5571-BZ
Questions or problems? Before returning to your retailer, call our
technical service department at 1-800-858-8501 (English speaking
only), 7:30 am to 4:30 pm, CST, Monday – Friday.
This quartz halogen fl oodlight disperses light over a wide area, at-
taches to a standard junction box and is for use with 120 VAC.
PACKAGE CONTENTS
• Floodlight • Bulb
• 2 Rubber plugs • Gasket
• Wire connectors • Mounting hardware
READ ALL INSTRUCTIONS CAREFULLY BEFORE
BEGINNING INSTALLATION.
NOTE: All wiring must be run in accordance with the National
Electrical Code through conduit or another acceptable
means. Contact a qualifi ed electrician if there is any ques-
tion as to the suitability of the system.
FIXTURE INSTALLATION INSTRUCTIONS
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and fl athead screwdrivers
• Pliers • Wire strippers/cutters
• Safety glasses • Silicone caulk
• Ladder • Black tape
To avoid Electrical Shock:
WARNING: Turn power off at the circuit breaker or
fuse.
Black to Black
Canopy
White to White
WIRING FIXTURE
(Product May Vary from Illustration)
© 2007 HeathCo LLC
• Follow all warnings listed on fi xture.
• Grounding and installations must comply with local codes and
• This product should be mounted on a grounded junction box and
• Permanently mount the fi xture to a building or pole.
1. Thread aiming arm into the enclosed canopy and tighten. Apply
2. Connect the fi xture wires to the power source wiring. Secure
3. Attach the canopy to the junction box (Apply silicon caulk be-
• Allow fi xture to cool before touching. The bulbs and fi xture
• Keep fi xture at least 2" (51 mm) from combustible materials.
• Replace bulb with up to 150W (max.) T3 halogen 120 VAC bulb
4. Loosen the side bolt connected to the arm to aim the fi xture up
5. To avoid water entering fi xture, do not aim the fi xture above the
IMPORTANT: Use a clean glove or cloth when handling the
Fixture ground to
new bulb. Oil from your hand may cause the bulb to crack when
junction box ground.
the fi xture heats up and result in premature failure. Use isopro-
pyl (rubbing) alcohol to clean the bulb if it is touched with your
bare hands.
1. When replacing bulb, turn power off and let the fi xture cool.
2. Remove glass cover and remove the old bulb by pushing the
3. To insert the new bulb push the bulb into the right socket so the
4. Re-install the glass cover.
5. Reconnect the power.
Quartz Halogen
Floodlight
the National Electric Code.
must be used with the canopy included.
silicon caulk to joint for a raintight seal. Seal the remaining holes
with the enclosed canopy plugs.
with wire connectors.
tween canopy and junction box for a raintight seal). Keep the
fi xture horizontal (within +/- 4º) so the bulb inside is horizontal.
If the bulb is not horizontal, the bulb may darken or shatter
and fail prematurely.
CAUTION to avoid fi re or burn hazards:
operate at high temperatures.
Do not aim at objects closer than 3 feet (1 m).
only.
and down.
horizon.
BULB INSTALLATION AND REPLACEMENT
bulb towards the right until the left side of the bulb is clear of
the left socket.
bulb is properly seated in the sockets.
598-1298-01