Niles ZR-4 Installation Manual page 21

to that input until a signal is no longer detected. The paging input
will play in all zones at the preset volume. If there are zones that the
end-user does not desire to receive a page, follow these steps.
While in the configuration mode (see above). Press the Band Key
until shows in the display. A cursor will be
[ 1234 PAGE MASTER ]
blinking under the number "1."
1 2 3 4
P P P P
Press the key to toggle between the zones to highlight a paging zone.
+
The cursor under the zone number blinks when a zone is highlighted.
Press the key to deselect a highlighted zone as a paging zone.
Set
A will disappear below that zone number.
[ P ]
Once you reach "4" it will toggle back to "1" on the Slave. Once you
have reached "4" on the Slave it will toggle back to "1" on the Master.
1 2 3 4
P P
Repeat these steps until all of the desired zones have been set for
your desired paging operation.
To continue to the next system configuration Party or Whole House
Mode, press the Band key once. To save your settings and to exit the
configuration mode, simultaneously hold down the
[ RELEASE BUTTONS TO CONTINUE ]
to the source that was playing before entering the configuration mode.
R E L E A S E B U T T O N S
T O C O N T I N U E
PARTY OR WHOLE HOUSE MODE
This feature lets the end-user press-and-hold any
three seconds to turn On the entire house to the same source for a
party. It also allows for the press-and-hold of the
the entire system from one zone keypad without the need to walk
around to every keypad to do so. By default all zones will respond
to Party mode. If there are zones that the end-user does not want
to turn on when a press-and-hold is initiated, follow these steps.
NOTE: THIS FEATURE ONLY DEACTIVATES THE PRESS-AND-HOLD
OFF OFF
. THE IS ALWAYS AVAILABLE AT ANY ZONE REGARDLESS OF ITS SETTING.
While in the configuration mode, (see above) press the Band Key
until shows in the display. A cursor will be
[ 1234 PARTY MASTER ]
blinking under the number "1."
1 2 3 4
W W W W
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
P A G E
M A S T E R
P A G E
M A S T E R
and keys.
Band Set
appears on the display. You will return
Key for
Master
key to turn
Off
ON
AND NOT THE
P A R T Y
M A S T E R
Press the to toggle between the zones. The cursor under the
+
zone number blinks when a zone is highlighted.
Press the Set key to deselect a highlighted zone as a Party zone. A
will disappear below that zone number.
Once you reach "4" it will toggle back to "1" on the Slave. Once you
have reached "4" on the Slave it will toggle back to "1" on the Master.
1 2 3 4
W W
Repeat these steps until all of the desired zones have been set for
your desired Party operation.
To continue to the next system configuration Page Mode On Volume,
press the Band key once. To save your settings and to exit the
configuration mode, simultaneously hold down the Band and Set keys.
[ RELEASE BUTTONS TO CONTINUE ]
to the source that was playing before entering the configuration mode.
R E L E A S E B U T T O N S
PAGE MODE VOLUME
The paging volume level for all selected zones is adjustable.
While in the configuration mode, (see above) press the Band Key
until
[ PAGE MODE VOLUME = 60 ]
P A G E M O D E
V O L U M E = 6 0
key to increase the preset volume. Press the – key to
Press the
+
decrease the preset volume. The factory default setting is 60.
P A G E M O D E
V O L U M E = 3 4
Off
The volume range is from 0 to 99. Hold the Set key 2 seconds to
save the new page volume.
To continue to the next system configuration Default Turn On
Volume, press the Band key once. To save your settings and to exit
the configuration mode, simultaneously hold down the Band and
Set keys.
[ RELEASE BUTTONS TO CONTINUE ]
R E L E A S E B U T T O N S
You will return to the source that was playing before entering the
configuration mode.
P A R T Y
M A S T E R
appears on the display. You will return
T O C O N T I N U E
shows in the display.
appears on the display.
T O C O N T I N U E
(CONTINUED ON NEXT PAGE)
[ W ]
19