Husqvarna G483ST Owner's Manual page 7

3
CONTAINER MOUNTING (See Fig. 3)
1. Install one container to left side first. Install another
container to center position and one in right position.
NOTE: Left edge of right con tain er should always over lap
right edge of left con tain er at center supports.
2. Close cover and lock latches over center support
tubes. To lock and release latches, pull back on latch
handles.
COVER LATCH
HANDLES
CONTAINER
HANDLES
CENTER
SUPPORT
TUBES
FIG. 3
4
LOWER CHUTE (See Fig. 4)
1. Raise and hold deflector shield in upright position.
2. Place slot in lower chute over mounting tab on mower
and position lower chute over mower opening as
shown.
3. Hook rear latch into flange hole on back of mower.
4. Hook front latch into tab hole on front of mower.
CAUTION: Do not remove deflector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
DEFLECTOR
SHIELD
7
OPTIONAL
TAB
FRONT
LATCH
REAR LATCH
FIG. 4
FRONT
GAUGE
WHEEL