Specifications; Troubleshooting Guide - Utilitech Motion Sensor Light Control UT-5105-BZ Owner's Manual

SPECIFICATIONS

Horizontal Range . . . . Up to 70 ft. (21 m); 100 ft.
(30.5 m) with Range Boost.
[var ies with surrounding
temperature]
Vertical Range . . . . . . Up to 15 ft. (4.6 m)
Sensing Angle . . . . . . Up to 240° horizontal. Up to 80°
Vertical
Electrical Load . . . . . . Up to 300 Watt Maximum In-
candescent [Up to 150 Watt
Maximum each bulb holder.]
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and MANUAL
MODE
Time Delay . . . . . . . . 1, 5, 20 minutes
D B Timer . . . . 3, 6 hours, Dusk-to-Dawn
®
ual rite
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features in
products previously sold.
SYMPTOM POSSIBLE CAUSE
Lights will not come 1. Light switch is turned off.
on.
2. F l o o d l i g h t i s l o o s e o r
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect (Re-
5. Incorrect circuit wiring, if this is
6. Re-aim the sensor to cover de-
Lights come on 1. Light control may be installed in
in daylight.
2. L i g h t co n t r o l i s i n T e s t .
Lights come on for
1. Light control may be sensing
no apparent rea-
son.
2. R a n g e i s s e t t o o h i g h .
3. D
Lights turn off too
1. Sensor is in a relatively dark
late in Dusk-to-
Dawn setting
598-1292-03

TROUBLESHOOTING GUIDE

burned out.
is turned off.
check after dark).
a new installation.
sired area.
a relatively dark location.
(Set control switch to an
ON-TIME position).
small animals or automobile
traffic (Re-aim sensor).
(Reduce Range).
B Timer is on.
®
ual rite
location. (Relocate sensor, or
use 3 hr or 6 hr setting.)
SYMPTOM POSSIBLE CAUSE
Lights stay on 1. A flood bulb is positioned too close to
continuously.
the sensor or pointed at nearby objects
that cause heat to trigger the sensor.
(Reposition the bulb away from the
sensor or nearby objects).
2. Light control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective surface.
(Reposition sensor. Reduce Range).
3. Light control is in Manual Mode.
(Switch to Auto.)
Lights flash on 1. Heat or light from the bulbs may be
and off.
turning the light control on and off.
(Reposition the bulbs away from the
sensor).
2. Heat being reflected from other objects
may be affecting the sensor. (Reposi-
tion sensor).
3. Light control is in the Test mode and
warming up. (Flashing is normal under
these conditions. Turn Boost off.)
4. Light may be leaking through the flood-
lamp reflectors. (Replace the bulbs
with new high quality PAR 38 bulbs or
make sure the metal bulb protectors
are installed).
Lights flash 1. Sensor is detecting its own lights.
once, then stay
(Reposition bulbs to keep area below
off in Manual
the sensor relatively dark.)
Mode.
5