Assembly & Installation; Handle Assembly; Installation - NewAir AWR-460DB Owner's Manual

1. Upper zone temp
sensor
2. Upper zone light
3. Upper zone fan
4. Light switch
5. Lower zone
temperature
6. Exhaust vents
7. Upper zone
temperature
ASSEMBLY & INSTALLATION

HANDLE ASSEMBLY

Tools Required for Assembly: Phillips screwdriver (not included)
Estimated Assembly Time: 5 minutes
Before installation, attach the handle to the front of the unit with the included
screws. It may be necessary to push aside the rubber seal on the inside of the
door to reveal the screw holes.
Caution: Avoid over-tightening the screws, or you may cause damage to the
unit.

INSTALLATION

Before connecting the appliance to a power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of
a malfunction in the cooling system from handling during
transportation.
This appliance can either stand alone or be built in. Front grille must be
unobstructed.
Before operating your wine cooler for the first time, follow these steps:

Clean the interior surface of the unit with lukewarm water and a soft
cloth.
NEWAIR AWR-460DB DUAL ZONE COMPRESSOR WINE COOLER
8. °C/°F
Temperature
switch
9. Exhaust vents
10. Front grille
11. Foot
12. Glass door
13. Door seal
14. Handle
15. Lower hinge Display
screen
16. Lower zone temp
sensor
17. Lower zone fan
18. Lower zone fan
19. Lower zone light
20. Shelf
6