Jet Cool/Heat Operation; Auto Clean - Heat Controller VMH30SB-1 Owner's Manual

Operating Instructions

Jet Cool/Heat Operation

You can activate this operation by pressing the JET COOL BUTTON.
To change from jet cool mode to high fan speed cooling mode, press the JET COOL BUTTON or
INIDOOR FAN SPEED SELECTOR BUTTON or the ROOM TERPERATURE SETTING BUTTON again.
NOTE
• Jet cool function cannot be activated during heating or auto changeover operations.
• You can use jet heat function by pressing JET COOL BUTTON for heating operation.

Auto Clean

❏ During auto clean function, moistures left in indoor units after cooling operation or healthy dehumidification
operation can be removed.
1. Press the AUTO CLEAN BUTTON to activate this function.
AUTO CLEAN
2. Now whenever the unit is turned off, the indoor fan is still running for about 30
3. This dries up any remains of moisture & cleans the unit internally.
4. If you press AUTO CLEAN BUTTON again during operation, this function is
NOTE
❏ During auto clean function, only START/STOP BUTTON and AUTO CLEAN BUTTON can be used.
12 Room Air Conditioner
Jet cool function can be used to cool the room quickly in hot summer. When this
function is turned on, the air conditioner runs in cooling operation mode with super
high fan speed and 18°C(64°F) setting temperature for 30 minutes for fast and
effective cooling.
Similarly, jet heat function (available only in some models) warms up the room quickly
by operating at super high fan speed and 30°C(86°F) setting temperature for 60
minutes.
minutes internally without cooling or dehumidification operation. Also the louver is
closed.
cancelled.