Surround Sound Feature; Direct Code Entry - GE RM24927 Instruction Manual

Surround Sound Feature

The surround sound feature may be turned ON/OFF
by pressing the SURR
1. Press the SURR MODE button
until the desired mode is found.
2. Press DELAY+ or DELAY- to achieve the desired
delay affect.
3. Press the DSP ON•OFF
turn DSP (Digital Sound Processor)
ON or OFF.
4. Press the DSP mode button until the
desired effect is achieved.
5. Press the TEST button to listen to
speaker levels.
6. Press FRONT, CENTER,
or REAR buttons to
select speakers.
7. Press the LEVEL+ or LEVEL-
buttons to adjust speaker levels.
ON•OFF button.
button to
8

Direct Code Entry

1. Press and hold the CODE SEARCH
button until the red indicator stays on,
then release the CODE SEARCH button.
2. Press and release the desired device
button (TV, VCR, etc.). The red indicator
blinks, then stays lit.
3. Enter the 4 digit code
from the code tables
(on separate sheet).
Note: after a valid code
entry, the red indicator
turns off. For an invalid
code, the red indicator
flashes.
4. With your device on, press
ON•OFF. If the device turns off, no
further programming is required.
Note: If some buttons do not
operate your equipment, try one of
the other codes for your brand.
Write your codes down here for easy reference
later.
Type Type stored
TV
VCR1
VCR2
SAT
CBL
AUDIO
DVD
AUX
Code
TV
9