Operation; General Installation; Front Panel - ADS 3120 Plus Operation Manual

120w ac/dc mixer amplifier
Table of Contents

Advertisement

Audio Design Services Ltd., St David's House, Adcroft Street, Higher Hillgate, STOCKPORT SK1 3HW.

OPERATION

General Installation

ALWAYS ensure that the equipment is properly earthed (grounded).
Operating without an earth is dangerous and may cause high levels of
audible hum from the speaker outputs.
NEVER remove the top cover of the amplifier or make an internal adjustment
with the ac mains supply connected. All internal servicing should be
performed by a competent and qualified engineer.
DO NOT expose the unit to rain or moisture. If any fluids or foreign objects
should enter the unit, disconnect the power plug immediately.
DO NOT site the equipment in locations exposed to direct sunlight, near
heaters or other heat sources. Avoid locations with high humidity or dust
levels.
DO NOT obstruct the ventilation slots in the amplifier case and allow
adequate ventilation. (Ensure that a 1U ventilation panel is fitted above the
unit if the amplifier is rack-mounted.)
DO NOT run microphone cables near mains, data, telephone or 100V lines.
AVOID jointing the microphone cables if possible. If this is unavoidable, make
sure a good screen connector is used.
ALWAYS use a balanced or floating low impedance microphone on long
microphone runs, terminating in a balanced input.

Front Panel

1
2
1
OVERLOAD LED INDICATOR
2
3
4
5
6
3
4
5
MIC 1
MIC 2
MIC 3 / AUX 1
MIC 4 / AUX 2
MIC 5 / AUX 3
Page 7 of 16
6
7
8
7
BASS CONTROL
8
TREBLE CONTROL
9
MASTER GAIN
10
POWER LED
11
POWER ON/OFF SWITCH
9
10 11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents