Sundance Spas 880 Series Owner's Manual page 61

Summer Logic: In warm weather, the water temperature in the
hot tub may exceed the set temperature. This condition may occur
due to heat transference from the filter/circulation pump and jets
pumps. If the water temperature is higher than 95°F (35°C) and
rises two degrees above the set temperature, a "Summer Logic"
condition occurs that deactivates the filter/circulation pump and
CLEARRAY®. This safety feature cannot be altered! The filter/
circulation pump and CLEARRAY® will remain off until the water
temperature cools to the set temperature (except between 9am-
11am when the filter/circulation pump runs for it's mandatory 2
hour cycle.)
Note: Pressing the select button at this time will reactivate the circu-
lation pump and waterfall feature for 1 hour. To help prevent a "Sum-
mer Logic" condition, it may be necessary to reduce filter/circulation
pump cycle run times in warm weather.
Press the (MODE)
adjustments, first press the (CYCLE)
cycle programming mode. The LCD screen will display the following in
the upper right corner:
This means the system is ready to accept you changes to the start time
for cycle number one. Simultaneously, the large four-digit display in the
center of the screen displays the currently programmed start time for that
cycle. At this point, you have four options. You may:
1. Press (UP)
increments of 30 minutes.
2. Press (CYCLE)
cycles start time. With each press, the currently programmed status
will be shown in the large four digit display. To adjust any displayed
value, simply press the (UP)
3. Press (SELECT)
Time to Duration, with each press, the currently programmed
duration will be shown in the large four-digit display. Press (UP)
or (DOWN)
of 15 minutes.
4. Press (DISPLAY)
water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display.
button to select "Economy" mode. To make
*
or (DOWN)
button to display and adjust each subsequent
button to move down the menu from Start
button to adjust the duration in increments
button to save changes and recall the main
button to enter the filter
*Note: Number will vary
according to which filter
cycle is being programmed.
button to adjust the start time in
or (DOWN)
880 SERIES
button.
Page 55