Default Settings In The Menu Configure/View Scsi Controller Settings - Fujitsu Siemens Computers D1409 Tehnical Manual

Default Settings in the menu Configure/View SCSI Controller Settings

SCSI Bus Interface Definitions
SCSI Controller ID
SCSI Controller Parity
SCSI Controller Termination
Additional Options
Boot Device Configuration
Single Image
Master SCSI Controller
Select SCSI peripheral from which to boot
Boot SCSI Controller
Boot SCSI ID
Boot LUN number*
SCSI Device Configuration
Sync Transfer Rate (MB/Sec)
Packetized
QAS
Initiate wide negotiation
Enable disconnection
Send Start Unit Command****
BIOS Multiple LUN Support
Include in BIOS Scan
Advanced Configuration
Reset SCSI Bus at IC Initialization
Display <Ctrl><A> Message During BIOS Initialization
Extended Int 13 Translation for DOS Drives > 1Gbyte
POST Display Mode
SCSI Controller Int 13 Support
Domain Validation****
Support Removable Disks under Int 13 as Fixed Disks****
BIOS Support for Bootable CD-ROM****
* The setting is valid only if Multiple LUN Support is enabled (Enabled).
**** The setting is valid only if the Int 13 Support of the SCSI controller is enabled (
A26361-D1409-Z120-1-7619
Features
Default setting
7
Enabled
Enabled
Default setting
Press <Enter>
AIC-7902 at slot 00 00:04:00
AIC-7902 at slot 00 00:04:00
0
0
Press <Enter>
320
Yes
Yes
Yes (Enabled)
Yes (Enabled)
Yes
No
Yes
Press <Enter>
Enabled
Enabled
Enabled
Verbose
Enabled
Enabled
Disabled
Enabled
Enabled
English - 11
).