Maintenance And Cleaning; Lint Filter; Sensor - Blomberg DV 16540 NBL00 Owner's Manual & Installation Instructions

6

Maintenance and cleaning

Lint filter

Lint and fibers released from the laundry in to
the air during the drying cycle are collected in
the "Lint Filter".
C F
ibres and lint are formed during wearing
and washing.
A
Always clean the filter after each drying
cycle.
To clean the Filter;
1. Open loading door.
2. Remove the lint filter by pulling it up and
open the filter.
3. Clean lint, fiber, and by hand or with a soft
piece of cloth.
4. Close the filter and put it back in place.
C
You can clean the filter and filter area with
a vacuum cleaner.
C
Clogging may arise on the filter surface
after using your machine for some time; if
this occurs, wash the filter with water and
dry it before using again.

Sensor

There are humidity sensors in your machine
that detect whether the laundry is dry or not.
For sensor cleaning;
1. Open loading door.
2. Allow machine to cool off if drying has been
done recently.
3. Wipe the metal sensors with a soft cloth
dampened with vinegar and dry the sensors
afterwards.
C
Clean the metal sensors at regular
intervals (4 times a year).
A
Never use solvents, cleaning agents
or similar substances when cleaning
as these might cause fire and/or an
explosion!
22 - EN