Table of Contents
Advertisement
Technical information
Dimensions
Power supply voltage / frequency
Total power absorbed
Heater rating
Water pressure
Maximum load
Spinning speed
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of the
machine during transit must all be removed before
using your machine for the first time. These parts
and their securing means should be kept in case
the machine has to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturally
out the polystyrene basis. Take away this basis
(fig. 1).
Open the lid of the appliance and remove the
polystyrene and plastic wedges which block the
drum. Close the lid (fig. 2).
On the back part and with a spanner, remove
the two loosened spacers (A) (fig. 3).
The holes which are now visible must be closed
with the plugs (B) provided with the appliance
(fig. 4).
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
the hoses located at the back of your washing
machine (fig. 6).
FOR THE INSTALLER
height with panel
height without panel
width
depth
minimum
maximum
cotton
synthetics
wool
895 mm
850 mm
397 mm
600 mm
230 V / 50 Hz
2300 W (10 A)
1950 W
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
5 kg
2,5 kg
1 kg
from draining position "
Fig. 1
A
Fig 3
Fig 5
- 18 -
" to 900 rpm
Fig. 2
B
Fig 4
&#" *
Fig 6
&#" *
Advertisement
Table of Contents
