Download Print this page

Nanosat NP11G User Manual

Ieee 802.11b/g wifi bridge

Advertisement

Quick Links

NP11G WiFi Bridge — User Manual
1

Advertisement

loading

Summary of Contents for Nanosat NP11G

  • Page 1 NP11G WiFi Bridge — User Manual...
  • Page 2 NP11G WiFi Bridge — User Manual 1. Introduction Thanks for choosing Nanosat NP11G WiFi Bridge. This portable device works best with Nanosat Receivers to access wireless network easily. A must have for Homestream, IP Movie (Video Club) and IP Radio.
  • Page 3 Please use power supply with the polarity as shown below. Power supply with different polarity will damage NP11G and the devices which the power supply belongs to. Seller will NOT be responsible for the loss caused by using the incorrect power supply. (Both Power Jack and Power Port are com-...
  • Page 4 NP11G WiFi Bridge — User Manual 2. Setup Please set this NP11G before using it, you can connect it to PC and run the NP11G_Setup.exe in the CD. The Physical Connection for Setup as below:...
  • Page 5 NP11G WiFi Bridge — User Manual 1) Please put into the CD-ROM, the system will automati- cally eject the disk and guide page, please refer to the right picture and click the corresponding label. 2) Please click Install Software label to run the set up pro- gram, if it’s shown the right picuture, please click Next,...
  • Page 6 NP11G WiFi Bridge — User Manual 3) If it’s shown the right picture, please click Yes to install- WINPCAP program. 4) Please click Next, don’t need to do other settings until Finish.
  • Page 7 NP11G WiFi Bridge — User Manual 5) After the installation is complete, please double click the desktop icon , the right picture shows it is searching the product MAC. 6) Please click Next, don’t need to do other settings until Finish.
  • Page 8 NP11G WiFi Bridge — User Manual 7) The right picture shows the product has searched the- WiFi network, please choose the correct WiFi Network. WPA automatically uses TKIP with dynamic encryption keys. Enter a passphrase on this screen. Encryption - TKIP is automatically selected as the encryption method.
  • Page 9 NP11G WiFi Bridge — User Manual WEP (128-Bit) or WEP (64-Bit) Enter a passphrase in the Passphrase field and click Next. If you want to manually enter a WEP key, leave the Passphrase field blank and click Next. Key 1-4 - One to four fields will be displayed, depending on the level of encryption you have selected. The WEP key you enter must match the WEP key of your wireless network.
  • Page 10 NP11G WiFi Bridge — User Manual Make sure the Bridge’s Wireless LED is solidly lit or flashing. This indicates that the Bridge has connected to the wireless network. If the attempt succeeds, proceed to screen 12. If the attempt fails, you have two options offered by a pop-up screen.
  • Page 11 Exit to exit the installationWizard. To make sure NP11G is working, cut off all other internet connection to the PC (only reserve the connection between the PC and NP11G). If you setup NP11G successfully, the PC can view internet now.