Configuring Video Motion Detection; Table 4-8 Scene Change Threshold Values - Honeywell EQUIP HD3MDIP User Manual

Configuring Video Motion Detection

Document 800-04132V1 Rev A
01/10
2. In the Scene Change Threshold list, select one of the following options:
Table 4-8 Scene Change Threshold Values
Value
High (80%)
Medium (50%)
Low (30%)
3. Click Apply.
Note To turn off camera field of view change detection, select Disable in the Scene
Change Threshold list. Disable is the default value.
Note You must click Apply after you make changes to any settings to save those
changes. Settings are not saved unless you click Apply.
For motion detection, an Administrator can enable and configure up to 5 zones within a
scene. The enabled and configured zones will be monitored for motion.
1. Click the Region drop-down menu, then select a region from the five available.
2. Click the VMD drop-down arrow, and select Enable.
The Regions appear in their default positions.
3. Click Apply.
4. Click and drag the box to resize and place it over the camera image.
5. Select the sensitivity level (High, Medium, Low).
HD3MDIP/X Network Camera Reference Guide
To detect ...
Maximum change in the camera field of view. The alarm
message appears when tampering causes at least an 80%
change in the HD3MDIP/X camera field of view.
Medium change in the camera field of view. The alarm
message appears when tampering causes at least a 50%
change in the HD3MDIP/X camera field of view.
Minimum change in the camera field of view. The alarm
message appears when tampering causes at least a 30%
change in the HD3MDIP/X camera field of view.
61