Breville BPR600XL Instruction Book page 63

TROUBLESHOOTING
PROBLEM
EO is displayed on
LEd Screen
E1 is displayed on
LEd Screen
E2 is displayed on
LEd Screen
E3 is displayed on
LEd Screen
The appliance automatically
switches to Keep Warm
without going through a
complete cooking cycle
Air is escaping from the rim
of the lid
Steam is released from the
pressure indicator valve
during cooking
The pressure indicator rod
does not rise in PRESSURE
COOK setting
Lid is hard to open or cannot
be opened
BPR600XL_IB_B13.indd 63
EASy SOLUTION
a. Check that lid is closed properly.
b. Check that the Pressure Release Valve is in the
correct position.
c. Make sure the silicone rubber gasket is attached
properly to the gasket holder and is securely in place
on the lid.
• Unplug unit and allow to sit for 20 minutes. If no
change, Please call Breville Consumer Service.
• Ensure the cooking bowl is properly positioned
inside base. The cooking bowl must be in direct
contact with the heating plate. Make sure there are
no unwanted materials on the heating plate.
• Ensure the lid is off the appliance or placed on top
to rest in an offset position when you are using the
SAUTÉ/SEAR setting.
• Add more water to cooking bowl and restart the
cooking cycle.
a. Install sealing gasket correctly.
b. Clean sealing gasket.
c. Replace sealing gasket.
d. Lock lid again.
a. Clean sealing gasket.
b. Replace sealing gasket.
c. Change silicone rubber gasket every 1–2 years.
a. Place Pressure release valve in the correct position.
b. Place more food and water in the cooking bowl.
c. Call Breville Consumer Service.
a. Check if the pressure indicator locking pin is in the
upright position. If it isn't, push down with aid of a
pencil or like item, jiggle the lid and disengage. This
will allow the air to escape and the lid should open.
63
18/01/13 1:03 PM