Table of Contents
Advertisement
8
Setting the water softener
Clarke
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
The water softener must be set in both ways: manually, using the water hardness dial and
electronically.
Setting manually
The dishwasher is factory set at position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position 1
or 2 (see table).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press simultaneously and keep pressed buttons B and C , until the lights of buttons A ,
B and C start flashing.
3. Press button A , the lights of buttons B and C turn off while the light of button A goes
on flashing. In the digital display will show the current level and a sequence of inter-
mittent audible signals are heard.
Examples:
displayed, 5 intermittent audible signals, pause, etc... = level 5
displayed, 10 intermittent audible signals, pause, etc... = level 10
Water hardness
°TH
mmol/l
91 - 125
9,1 - 12,5
76 - 90
7,6 - 8,9
65 - 75
6,51 - 7,5
51 - 64
5,1 - 6,4
40 - 50
4,0 - 5,0
33 - 39
3,3 - 3,9
26 - 32
2,61 - 3,2
19 - 25
1,9 - 2,5
7 - 18
0,71 - 1,8
< 7
Adjusting the water hardness
manually
2
2
2
2
2
2
1
1
1
< 0,7
1
setting
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
Use of salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no
Advertisement
Table of Contents
