Kenmore 146.23680310 Use & Care Manual page 24

Side burner
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws holding side
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with previously
□ Place side burner tube over the valve, making sure that valve is inside side burner tube. (F)
□ Push control knob onto side burner valve stem. (G)
□ Reattach side burner to side burner shelf with the 2 previously removed screws. Replace side burner
□ Connect both igniter wires to the igniter module on the inside of the right fascia. To connect, push
□ Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery
C
E
24·146.23680310
burner in place. (A). Note: Do not loosen electrode screw.
removed 2 screws. Attach bezel with black mark facing up (E).
grate. (H)
igniter wire tips onto pins in igniter module.(I)
slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
A
B
D
F