Husqvarna 966529102 Operator And Parts Manual page 9

4
INSTALLING DRIVE BELT
1. Make sure the tension release lever is forward
(disengaged).
2. Place the belt over the pulley on the deck. Refer
to illustration for proper routing.
3. Move the tension release arm to the rear and
engage in the latch.
Tension
Release Arm
Idler Pulleys
Rear of Deck
5
INSTALLING BELT COVERS
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the
end of the outer pulley cover.
4. Secure with knob.
Belt
Cover Tab
Deck Belt Shield
Outer Pulley Cover
ASSEMBLY
6
1.
2.
Outer Pulley
8063-074
8063-047
Twist in Belt
3.
4.
Retainer
8063-048
8063-079
INSTALLING CHUTE SUPPORT
Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
Using support as a template, drill two
bagger hood.
Upper Chute
Support
Secure upper chute support to hood with hex
bolts, washers and nyloc nuts. Use the illustration
for hardware orientation.
Slide the flex trim over the support and bagger
edge.
Upper Chute
Support
/ holes into
3
8
Bagger Inlet
Flex Trim
9