Installing The Add-On Cards; Installing Add-On Cards In Low-Profile Model Chassis - Supero SC213A-R900UB User Manual

4-8

Installing the Add-on Cards

Add-on card installation in the SC213 chassis differs between the UIO and low-
profile chassis models. See below for directions that are specific you your chassis
type.
Installing Add-on Cards in Low-Profile Model Chassis
Installing Add-on Card Brackets - Low-Profile Chassis Models
1. Remove the chassis cover and ensure that the motherboard has been prop-
erly installed.
2. Locate the vertical add-on card slots in the rear of the SC213 chassis.
3. Remove the blank bracket which is pre-installed in the chassis.
Figure 4-9: Removing the Blank Add-on Card Bracket
4. Simultaneously slide the add-on card carefully into the bracket and plug it into
the slot on the motherboard.
5. Screw the add-on card bracket onto the chassis.
Figure 4-10: Installing the Low Profile Add-on Card
Chapter 4: Chassis Setup and Maintenance
4-9