Controls; Osm (On-Screen-Manager) Controls - NEC MultiSync LCD1560VM User Manual

NOTE: This LCD monitor is designed for use with a flexible arm. Please use the attached screws (4pcs) when mounting.
To meet the safety requirements the monitor must be mounted to an arm which guaranties the necessary stability
under consideration of the weight of the monitor. The LCD monitor shall only be used with an approved arm (e.g.
GS mark).

Controls

OSM (On-Screen-Manager) Controls

The OSM controls on the front of the monitor function as follows:
To access OSM press any of the control buttons (<, >, -, +, EXIT).
To change signal input, press the SELECT button.
NOTE: OSM must be closed in order to change signal input.
Control Menu
EXIT Exits the OSM controls.
Exits to the OSM main menu.
< / > Moves the highlighted area left/right to select control menus.
Moves the highlighted area up/down to select one of the controls.
- +
/ Moves the bar left/right to increase or decrease the adjustment.
SELECT Active Auto Adjust function. Enter the OSM controls. Enter the OSM sub menu.
RESET/MUTE Resets the highlighted control menu to the factory setting.
When no OSM menu is shown, the speaker sound will be muted.
NOTE: When RESET is pressed in the main and sub-menu, a warning window will appear allowing you to cancel the
RESET function by pressing the EXIT button.
01_English
Replace screws
4 SCREWS
(MAX depth: 8.6 mm)
If use other screw,
check depth of hole.
Weight of LCD assembly: 3.5kg (MAX)
6
75 mm
75 mm
English-6
16/10/02, 5:16 pm
Thickness of bracket (arm)
2.0 ~ 3.2 mm
Tighten all screws