Table of Contents
Advertisement
TROUBLESHOOTING
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem
Solution
See
page
No power
Connect the AC power cable properly.
14
Press STANDBY ION on the front panel of this unit to turn on the
15
power.
No picture
Refer to the manual supplied with your TV for correct Video In
-
channel selection. Change the TV channel until you see the DVD
screen.
Turn on your TV.
-
Make sure that all connections on this unit and on all other
10
components are secure.
If [Component] is set to [Progressive], check that you have connected
35
this unit to a progressive scan TV through the component video jacks.
Otherwise, follow the steps below to turn off the progressive scan;
I. Press
.6.
on the front panel to open the disc tray.
2. Press CLEAR on the remote control.
3. Press "2580" using the numeric buttons (0-9) on the remote
control.
4. Press AUDIO on the remote control.
If [HDMI Video] is set to other than [Auto], check that the resolution
36
is supported by the HDMI-compatible monitor you have connected.
Otherwise, follow the steps below to change the setting to [Auto];
I. Press
0 twice on the front panel or STOP ( • ) twice on the
remote control to stop playback.
2. Press and hold 0 and l>AlD on the front panel at the same time for
three seconds.
If the HDMI indicator flashes orange, check that you have connected
12
this unit to an HDCP-compatible component.
Check that the video signal output setting matches the video
36
connection.
Completely distorted picture or
Check that the disc is compatible with this unit.
3
black/white picture
Check that the TV type of this unit is set to match that of the disc and
16
your TV. If you set the TV type improperly, follow the steps below to
restore the TV Type setting to the default setting;
I. Press
.6.
on the front panel to open the disc tray.
2. Press CLEAR on the remote control.
3. Press "2580" using the numeric buttons (0-9) on the remote
control.
4. Press AUDIO on the remote control.
Check the video connection.
II
The screen size looks unnatural,
Check that the TV setting of this unit matches the screen aspect ratio
34
or the caption Is displayed only
of your TV.
partially on the TV monitor or Is
Change the screen size and the aspect ratio of your TV.
not displayed at all
-
40
En
Advertisement
Table of Contents
