Epson PowerLite 1750 Maintenance Manual

Epson PowerLite 1750 / 1760W / 1770W /1775W

Air Filter and Vent Maintenance

The projector's air filter keeps the intake air clean, and its vents expel the exhaust. If dust collects on the
air filter or vents, clean them as described in this manual. Dust clogs may cause the projector to overheat
due to improper ventilation.
Be sure to clean the air filter and vents if you see a message telling you to do so. Also make sure nothing
blocks the vents.
Cleaning the Air Filter and Vents
Be sure to clean the projector's air filter or vents if they get dusty, or if you see a message telling you to
clean them.
1. Turn off the projector and unplug the power cord.
2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in
water, or use any detergent or solvent to clean it.
3. If dust is difficult to remove or the air filter is damaged, replace the air filter.
Replacing the Air Filter
You need to replace the air filter in the following situations:
• After cleaning the air filter, you see a message telling you to clean or replace it
• The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling, if necessary.
1. Turn off the projector and unplug the power cord.
INSTALLATION HANDBOOK
Maintenance
1