Table of Contents
Advertisement
Programming a Security Code
With the phone in standby, open the menu; select Answering
Security
Code. Use the number keypad to enter a two-digit security code (01 to 99).
Press
when you're finished.
MEnu/SELEcT
#
Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number & wait until the system answers. (If the system is turned
off, it answers after 10 rings & sounds a series of beeps.)
2. During the greeting or beeps, press 0 and immediately enter your security code.
If you enter it incorrectly 3 times, the system hangs up and returns to standby.
3. The system announces the time, the number of messages in memory, and a help
prompt. It beeps to let you know it's waiting for a command.
4. When you hear beeping, enter a 2-digit command from the chart.
#
If you don't press
any keys for 15
seconds, the
system hangs up
and returns to
standby.
IMPORTANT INFORMATION
Solving Problems
If you have any trouble with your phone, check this section first. If you need help,
call our Customer Care Line listed on the front cover.
General problems
No handsets can make or
receive calls.
A handset can't make or
receive calls.
A handset can make calls,
but it won't ring.
A handset is not working.
The phone keeps ringing
when I answer on an
extension.
01
Repeat message
02
Play message
03
Skip message
04
Delete message
Possible solutions
x Check the telephone cord connection.
x Disconnect the base AC adapter for a few minutes;
then reconnect it.
x Move the handset closer to the base.
x Make sure the ringer is turned on.
x Make sure Silent Mode is turned off (see page 13).
x Charge the battery for 15-20 hours.
x Check the battery connection.
x You may have to change the line mode. Contact
Customer Service for instructions.
Setup, then select
05
Stop playback
06
Turn the system on
09
Turn the system off
10
Hear help prompts
English - 19
Advertisement
Table of Contents
