Kenmore 790.31113 Use And Care Manual page 10

Setting Surface Burner Controls
MED
OFF
OFF
LITE
Figure 1 - Regular Burner Knobs
Setting the Bridge Burner
OFF
LITE HI
Figure 2 - Bridge Burner
Setting the Simmer / Regular / Power / Turbo Boil Burners
Operating the Regular Burner:
1.
2. Push the surface control knob down and turn counterclockwise out of the
3. Release the knob and rotate to the LITE position.
LO
4. Visually check that the burner has a flame.
5. Once the burner is lit, continue to turn counterclockwise to the desired
MED
HI
Setting the Bridge Burner
The Bridge Burner should be used with
rectangular shaped cookware. Cookware like
LO a cast-iron Griddle is designed specifically for
bridge
best results with the Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2
or if needed 3 gas surface Burners located along the left-hand side of the
HI
cooktop. The left rear and left center Burners are controlled by the left rear
bridge
surface Control Knob. In addition the left front Burner may be added to the
Bridge Burner with the left front gas Control Knob.
LO
Operating the Bridge Burner
1.
2. Release the knob and rotate to the LITE position (See Figure 2). Note: All
3. Visually check that the rear Burner has lit.
4. Continue to rotate the gas control knob counterclockwise past the first LO.
5. Visually check that both the rear and center Burners are lit.
6. When both Burners are lit, continue to turn the control knob
7. Add the front Burner if needed. Once lit, visually adjust the flame size of
LITE position (The electronic ignitor will continue to spark if the knob is left in
the LITE position).
Note: If only the rear surface Burner is needed, adjust the settings between
the 1st HI and LO.
Note: The front Burner may be added to the Bridge Burner by setting the left
front gas Control Knob.
Place cooking utensil on surface burner.
OFF position (See Figure 1).
Note: All four (or five) electronic surface ignitors will spark at the same
time. However, only the burner you are turning on will ignite.
flame size. The control knobs DO NOT have
to be set at a particular setting. Use the
knob indicator settings to adjust the flame
as needed.
with the surface control knob in the LITE
position (The electronic ignitor will continue
to spark if the knob is left in the LITE
position).
Push the left rear surface control knob in and turn counterclockwise out
of the OFF position (See Figure 2).
electronic surface ignitors will spark at the same time. However, only the
selected surface Burner will lite.
counterclockwise to adjust to the desired flame size for both Burners
together. Note: The markings between bridge HI and bridge LO settings
on the control knob are used for adjusting the flame size for both burners.
the front Burner to match the flame size of the Bridge Burner.
DO NOT cook with any of the surface control knobs in the
10
DO NOT cook
T u
r n
e
w i s
C o u n
t erc l o c k