Dear Customer! Thank you for your good choice and purchase of a remote control unit for a Timberk infrared heater. It will serve you long TMS 08.CH model remote control unit is designed to control TCH A1N, TCH A2 infrared heater.
The changes in the set-list may result in changing of the weight and dimensions of the device, but not more than by +\- 5-20% (depending on the product category) www.timberk.com remote control block...
For a more detailed description of technical parameters and characteristics go to www.timberk.ru or ask TIMBERK o cial dealers. 5. DIMENSIONAL FEATURES Overall dimensions of the remote control unit in mm are given in Fig.1. Fig. 1 www.timberk.com remote control block...
Page 5
6. Description of the remote control unit The remote control unit consists of a control unit and a remote controller. Control unit (Fig. 2) Fig. 2 1. POWER indicator 2. IR-signal receiver 3. Heat indicators 4. Timer indicators www.timberk.com remote control block...
Page 6
To mount batteries: 1. Remove the cover of the battery compartment by sliding it along the direction of the arrow. 2. Mount batteries, observing speci ed polarity. 3. Place the cover back. www.timberk.com remote control block...
It is used to switch an infrared heater on and o . 6. MODE button It is used to program modes in accordance with the infrared heater model. 7. HEAT button It is used to select heating power modes (except TCH A2). Fig. 3 www.timberk.com remote control block...
Electric Installation Code and Safety Rules for Operation of Electrical Installations Operating at Voltage Up to 1000V . IMPORTANT! All work to connect the control unit to an infrared heater must be performed only after it is completely de-energized. www.timberk.com remote control block...
Page 9
5. After the unit is connected, switch 2 on the control unit must be switched ON (see Fig. 4), place the top cover of the control unit back and secure the unit on an infrared heater. www.timberk.com remote control block...
Page 10
4. The unit must be connected to the electric mains by the cable with strand cross section not less than 1.5 mm2 and along with installation in the electric mains of a circuit breaker with rated current not less than 16A. www.timberk.com remote control block...
Page 11
5. After the unit is connected, switch 1 on the control unit must be switched ON (see Fig. 5), place the top cover of the control unit back and secure the unit on an infrared heater. 800W/1000W Relay Heating element 220V~ Fig. 5 www.timberk.com remote control block...
Page 12
If the mode is selected incorrectly, the control unit will make a triple sound signal. In this case the mode must be reselected according to the heater model, to do this press MODE button and hold it for 5 seconds, then repeat the above actions. www.timberk.com remote control block...
Page 13
4.2. Press « » or « » button to set the heater switch o time, with 1 hour increment, 0 to 13 hours. The display will show the countdown of time, remaining till the heater is switched www.timberk.com remote control block...
Page 14
The water heater should be disposed upon the end of life in compliance with codes, rules and methods in use at the disposal site. You can obtain detailed information on the remote control unit disposal from a representative of local authorities. www.timberk.com remote control block...