Reset To Factory Default Settings - Bosch ICP-AMAX4-P2-EN Quick Start Manual

AMAX panel 4000 / AMAX panel 4000
EN
4.
For LED/Icon LCD keypad, the programming data is displayed by the keypad indicator. See
Programming Data Indicators, page 11.
Notice!
For LED/Icon LCD keypad, when the programming data exceeds the display range of the
keypad indicator, there will be no display on the keypad.
Programming Data Indicators
Data
Value
4.2

Reset to Factory Default Settings

The factory Default can be reset with the 'Resetting to Factory Default' pads on the main
board of the control panel.
1.
2.
3.
Bosch Sicherheitssysteme GmbH
– Enter the next address: Press [#]
– Back to the previous address: Press [*]
– Skip to other address: Enter the address code and press [#]
– Set new data in the address: Enter new data values and press [*]
– Enter new data values as required. Otherwise, the factory Default will be used in the
system.
Exit programming mode: Enter Command [9] [6] [0] and press [#] to save programming
data. Entering [9] [5] [9] + [#] means not to save the programming data.
Zone Indicators
1 2
0
1 X
2 X
3
4
5
6
7
8
9 X
10
11 X
12 X
13
14
15
Disconnect the AC power supply and backup battery to the control panel.
Short-circuit the 'Resetting to Factory Default' pads.
These set of pads are located at the top on the printed circuit board of the control panel.
3 4 5
X
X
X
X
X
X
Quick Start Guide
Configuration | en
6 7 8
X
X
X
X
2013.07 | 03 | F.01U.267.113
11
Mains
X
X
X
X
X
X