Ford EDGE 2013 Owner's Manual page 306

Hide thumbs Also See for EDGE 2013:
Table of Contents

Advertisement

Replacing HID headlamp bulbs (if equipped)
The low beam headlamps on your vehicle use a "high intensity discharge"
source. These lamps operate at a high voltage. When the bulb is burned
out, the bulb and starter capsule assembly must be replaced by your
authorized dealer.
Replacing front parking lamp/turn signal bulbs
1. Make sure that the headlamp control is in the off position.
Replacing tail/stop/turn/sidemarker/backup lamp bulbs
4. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
5. Pull bulb straight out of socket and snap in the new bulb.
6. Install the bulb socket into the lamp assembly and rotate clockwise.
7. Carefully install the tail lamp assembly on the vehicle by securing the
lamp assembly with two bolts.
2013 Edge (edg)
Owners Guide gf, 4th Printing, November 2012
USA (fus)
Maintenance
2. Open the hood.
3. Reach over the front bolster.
4. Rotate the bulb socket
counterclockwise and remove from the
lamp assembly.
5. Carefully pull the bulb out of the
socket and push in the new bulb.
6. Install the bulb socket into the lamp
assembly and rotate clockwise.
1. Make sure the headlamp switch is
in the off position, then open the
liftgate to expose the lamp assembly
bolts.
2. Remove the two bolts from the
lamp assembly.
3. Carefully remove the lamp
assembly away from the vehicle by
pulling the assembly straight out to
expose the bulb socket.
305

Advertisement

Table of Contents
loading

Table of Contents