Quick Start Guide; Inserting Batteries In The Remote Control - Sharp LC-32BD1 Quick Start Manual

Quick Start Guide

Part Names
Inserting batteries in the
remote control
1
Open the battery cover.
2
Insert the supplied two AAA
batteries, and close the cover.
Cautions regarding batteries
Improper use of batteries can result in chemical
leakage or explosion. Be sure to follow the
instructions below.
• Do not mix batteries of different types.
• Do not mix old and new batteries.
CAUTION
• Do not try to charge or disassemble
batteries.
• Place the batteries with their terminals
corresponding to the
• Do not short-circuit batteries.
• The supplied batteries may have a shorter life
expectancy due to storage conditions. Replace
Note Note
them with new ones before they are depleted.
• Remove the batteries from the remote control, if
you will not use it for a long time.
• If, after replacing batteries, the remote control
does not work, make sure the new batteries are
placed in the right direction.
-
Remote Control Unit
and indications.
Remote control operating range
When operating the remote control, direct its head toward
the remote sensor window located at the bottom right
corner of the main unit, as shown below. The maximum
operating range is approximately 5 meters in distance, and
30 degrees in angle against the straight line normal to the
remote sensor window, as shown below.
Note:
• The remote control may not work when there is an
obstacle between the remote control and the main unit's
remote sensor window.
• As the batteries are depleted, the operating distance will
become shorter. Replace them with new ones.
• The remote control may not work properly when there
is a fluorescent light near the main unit's remote sensor
window.
Cautions regarding the remote control
• Do not expose the remote control to shock, water, or
high humidity.
• The remote sensor window on the main unit may not
properly receive remote control signals when it is
under direct sunlight or strong lighting. In such a case,
change the angle of the lighting or the main unit.