Panasonic Toughbook CF-47 Series Operating Instructions Manual page 22

List of Error Codes
02F5: DMA Test Failed
02F6: Software NMI Failed
02F7: Fail - Safe Timer NMI Failed
device address Conflict
Allocation Error for: device
CD ROM Drive
Entering SETUP ...
Failing Bits : nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
PS/2 Mouse Boot Summary Screen:
nnnn kB Extended RAM Passed
nnnn Cache SRAM Passed
nnnn kB Shadow RAM Passed
nnnn kB System RAM Passed
Operating system not found
Parity Check 1 nnnn
Parity Check 2 nnnn
Press <F1> to resume, <F2> to Setup, <F3> for previous
Press <F2> to enter Setup
PS/2 Mouse:
System BIOS shadowed
UMB upper limit segment address : nnnn
Video BIOS shadowed
22
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
ServerBIOS2 test error: Fail-Safe Timer takes too long.
Address conflict for specified device.
Run ISA or EISA Configuration Utility to resolve resource conflict for the specified device.
CD-ROM Drive identified.
Starting Setup Utility.
The hex number nnnn is a map of the bits at the RAM address, which failed the memory test. Each 1 (one) in the map
indicates a failed bit. See error 230,231 or 232 for offset address of the failure in System, Extended or Shadow memory.
Fixed disk n (0-3) identified.
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict error.
PS/2 Mouse installed.
Where nnnn is the amount of RAM in kilobytes successfully tested.
Where nnnn is the amount of system cache in kilobytes successfully tested.
Where nnnn is the amount of shadow RAM in kilobytes successfully tested.
Where nnnn is the amount of system RAM in kilobytes successfully tested.
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: are
properly identified.
Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot
locate the address, it displays ????. Parity is a method for checking errors in binary data. A parity error indicates that
some data has been corrupted.
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the
address, it displays ????.
Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> to enter a Setup and
change the settings. Press <F3> to display the previous screen (usually an initialization error of an Option ROM, I.e.,
an add-on card). Write down and follow the information shown on the screen.
Optional message displayed during POST. Can be turned off in Setup.
PS/2 mouse identified.
System BIOS copied to shadow RAM.
Displays the address nnnn of the upper limit of Upper Memory Blocks, indicating released segments of the BIOS
which can be reclaimed by a virtual memory manager.
Video BIOS successfully copied to shadow RAM.